How many hours you got on the bx?
Sep 11, Removal Tool for pulling / pushing out axle pivot bushings on a TTB front bushpruning.clubed Rodnylon nut or weld one on socket the size of the bushingreceiver fro. 6. Lower the axle removal 1. The pivot bush removal tool consists of: threaded rod – WS /4” (1) - two thrust washers (2) - thrust bearing (3) - cover plate (4) - receiver tube (5) - push plate (6) - drive nut – 2” (7) 2.
Before removal, lubricate the thrust bearing, threads on the threaded rod and drive nut with general purpose grease. Line: PFM. Hub & Axle Pullers. ☆☆☆☆☆ ☆☆☆☆☆. out of 5 stars. Read reviews for Performance Tool Slide Hammer. (4) Select a store to see pricing & availability. Sep 16, BX front axle bushing removal tool. My Kubota BX has developed a leak in the front axle pivot bushing.
Dealerships charge anywhere from to bucks to pull your front axle and replace the bushings. I wanted to find the correct tool to remove the bushings. The bushings on the front axle of the bx series tractors are not in blind holes.
You must log in or register to reply here.
Please SUBSCRIBE if you like this video!Easiest way to remove axle pivot bushings with minimal bushpruning.club Used here: Pneumatic"Metal Air Saw" from Harbor F.
Orion Motor Tech in-1 Custom Bushing Driver Tool Set and Transmission Wheel Axle Bearing Race Seal Installer Remover, Bush Removal Puller Bearing Press Tool Kit out of. Sep 11, just use an air chisel to push out the bushing sleeves. Apr 21, Apr 8, #3. eddie bauer said: I have a 91 Bronco and I was repacking the front wheel bearings and doing a brake job, and noticed that my axle pivot bushings were shot. I was curious if anyone has ever replaced these and how big of a pain they are to change.
I've done radius arm bushings before and figured on replacing these as well. Feb 09, Posted: Sat Feb 08, am Post subject: Re: Front axle pivot bushing install: Thanks Old, I pressed the old one out and was worried about distorting or crushing the new one as the OD of the bushing is" and the axle center hole is. Sep 06, Posted: Mon Sep 05, pm Post subject: Re: How can I remove the King Pin (Axle Pivot Pin) on my 8n?: You need to remove the motor mount to get the pivot pin out.
Enter a new vehicle.
The front flange on the pin is a teardrop shape. After you've removed the retaining bolt, use your drift on the side of the flange down low (narrow end of the teardrop)and your BFH to drive the flange toward the opposite.